How do I join the unspliced output cable to my hardwire kit?
Set the battery to OFF and disconnect power before working on the cables. Use a compatible regular camera hardwire kit. Prepare each wire to suit the supplied sleeve and wire gauge, match BATT+ to BATT+, ACC to ACC and GND to GND by label, then use a suitable crimping tool to secure each pair. Check that every joint is insulated and secure before reconnecting power. Follow both manuals or have a qualified installer make the connections.
Will every dash cam record for 24 hours?
No. Approximately 24 hours is the manual's reference for its 2CH setup. Camera power draw, parking settings, starting charge and any connected USB load affect runtime. Short trips may not replace all the energy used while parked.
Which charging setting should I use?
Set the pack to OFF before installation. Use LOW with the supplied cigarette socket input cable. HIGH is for the supplied hardwire input connected to a suitable ignition-switched ACC circuit; charging current can be adjusted in the app. Follow the manual and have the circuit checked by a qualified installer.
What does the hardwire installation require?
The manual specifies an ignition-switched fuse location with an original fuse rated at least 10A, the appropriate add-a-fuse and a sound chassis ground. This is the battery’s vehicle input; the camera connects separately to the battery’s output. Our battery installation guide explains the setup choices.
Will it keep drawing from my car battery while parked?
With the specified ignition-switched installation, vehicle charging stops when the ignition is off and the PowerCell supplies the camera. A permanently powered socket or constant-power fuse can keep drawing from the vehicle battery, so confirm that the chosen input switches off with the ignition.
Which camera hardwire kit do I need?
Use a regular, unspliced hardwire kit made for your exact camera and compatible with the battery’s 3-wire output. The camera hardwire kit is not included. This offer supplies one unspliced output cable and crimp sleeves; there are no selectable spliced cable options.
How do I add the current 6,800mAh extension?
Connect the Cellink NEO Extended Battery Pack IN/OUT (Auto) connector to the PowerCell 8 EXT. Battery port with the supplied transfer cable. The manual says the app capacity should update automatically. One extension gives a nominal total of 14,300mAh; two give 21,100mAh. Verify the displayed total after connecting; if it has not updated, follow the app instructions or contact support.
Should I change the app password?
Yes. The manual recommends changing the default password, 1234, after purchase. Choose four digits from 0001 to 9999; 0000 is not allowed. Keep the new password somewhere you can retrieve it and contact support if you forget it.
What should I know about heat and mounting?
Install the pack in a dry, ventilated location away from direct heat and moving seat mechanisms. Leave room for the connectors and cable bends. The manual’s 80°C internal protection cutoff is a fault-protection threshold, not a normal operating-temperature rating.
What warranty and return terms apply?
Our PowerCell 8 includes a 12-month BlackboxMyCar warranty and normal returns. See our warranty, returns and exchange policy for coverage, return conditions and support.